Wall and floor heating system
Anwendungsbereiche

Floor heating system

Floor application for the wedi Building Panel

wedi Building Panels are ideally suited for use beneath floor and even wall warming systems. The building panels’ good insulation properties keep the heat away from the ground and reflect it back up in to the room, regardless of whether you have a hot-water heating system or an electric system. wedi Building Panels save energy and provide shorter warm up times around your heating system. The warmth is evenly distributed across the entire floor.
Step 1 Step 1 Draw ducts / grooves onto the wedi Building Panel for installation of the heating system.
Step 2 Step 2 Cut grooves using a router. Cutting width should be the same as the pipe width; cutting depth should be at least 1/8” deeper. Make sure at minimum a remaining wedi panel foam thickness of 1/4" remains intact below the pipe.
Step 3 Step 3 Install tubing into the groove. Fill tile adhesive into the pipe duct to cover pipe and fill voids.
Step 4 Step 4 Apply wedi’s wide self adhesive reinforcement tape over the installed ducts. Start tiling. Tiles smaller than 4" x 4" should not be used over hydronic system installation surfaces.
Hot-water systems Hot-water systems For hot-water systems, ducts can be cut into the building panel and other wedi elements quickly and easily.
Hot-water systems Hot-water systems The building panel serves as a combined form of heat insulation and a base for installation of tile and serves as waterproofing protection if needed.

At a glance

Technical handbook 3.92 MB) Data sheet building panel 1.77 MB Data sheet Joint sealant 0.14 MB

wedi system components

wedi Building Panel wedi Accessories Meshtape

Data Protection